The reviews are automatic translation.
Dyeing of polyester fabric (petals)
On 2016-04-15 19:39:39
Center had been using a syringe into a hole how dyed put a dye that the dye a lot of dough for a short tip of the syringe for the Company to stain the fabric of the recent polyester manufacturers of artificial flowers it was difficult, but we were able to dye a lot of petals by the use of this nozzle. Speaking greed, is the length of the nozzle also want shorter than it is now.
The nozzle of the adhesive container
On 2015-12-09 13:48:35
Drug injected into the trees
On 2015-10-19 14:07:15
Use the drug injected into the holes of the beetles in the trees.
It is ideal for a little bending use the tip.
100 is also the same as price size is in the thing and looks dated injector of the average I think the more expensive.
Inhalation work of liquid
On 2014-11-06 16:10:42
Also created a robust, needle also long, is a handy nozzle that it can also be neatly inhalation excess liquid into a deep bottle bottom.
Adhesive Injection / Coating
On 2014-05-31 14:55:32
Size (both length and thickness) is appropriate and the price is cheap and good. However, it is possible to use it by the Bonde E set as much as possible. It is not quite suitable for the adhesive with higher viscosity - Quick Mender etc. Acrylic adhesive - methylene chloride etc. - When used it may want a smaller diameter. It is perfect if you have a narrow tip and a thick tip.
Plumbing internal scratch injection of fluorescent agent for fluorescent flaw detection etc.
On 2013-02-15 13:44:22
Fluorescent agents are difficult to clean up when spilled, but if this is done, it can inject well without dropping a single drop. Work efficiency has risen dramatically.
For bonding work
On 2012-11-06 15:52:07
The number of 1 unit is too many for 10, so I want you to sell about 5 items.
Work to dispose ink as dots continuously at a stroke.
On 2012-07-01 04:25:37
It was too thick to be useful. I experimented with viscosity considerably, but I could not use it with this thickness. I am hoping for thinner ones.
Injection of adhesive
On 2011-10-20 00:15:41
Thick, too fat. It has an outer shape of 1.3 mm. This can not be used for fine workmanship. Can you sell around 0.5 mm in outer shape
To inject resin into cracks in concrete.
On 2011-09-19 19:24:14
It was perfect fit for Terumo syringe and it was comfortable to use. If there is a product whose tip is flattened, it can be injected into a narrow gap. This time I cut the tip like a syringe needle and tried using it, but after all it leaked from the tip and it did not go well. It was possible to work comfortably if there was something like vinyl parts attached to the tip of Aron Alpha.