The reviews are automatic translation.
Movable motor shaft
On 2016-08-17 16:41:01
Cost performance large.
Against the price, it was a good thing.
Durability is unconfirmed.
As an axis of the reciprocating motion of the machine
On 2016-07-24 07:35:43
We chose in the cheapness. Since there is only 100mm and 300mm variations, but has to use the 100mm by devising the structure, did place 150mm want.
Used for processing jig
On 2016-04-25 18:31:26
Since the price is cheap is a buy to try. It's neither good nor bad. is.
As a material
On 2016-04-13 20:35:36
On 2016-01-12 20:08:23
Was able to firmly attached to the bearing unit has a higher accuracy in cheap split. In addition we want to increase the variation of the material and size.
On 2015-08-29 11:43:11
Usual choice. . .
... To create your own milling machine (Z-axis)
On 2015-06-20 02:54:26
Z-axis's because length is I no 100mm any problem, but I want to also make products of Φ10x300mm ~ 400mm for X · Y-axis.
After creating and get a Φ10x300mm ~ 400mm, I buy four for the X · Y-axis, but ...
Φ12mmx300m there is, but then I peripheral parts size, such as flange Bush shaft folder can not be shared.
In addition, depending on the manufacturer will raise the price of the peripheral parts somewhat.
Easier to rust because the surface plating treatment and lathing is eliminated, as the linear shaft I think accuracy drops considerably.
We want to sell in a 50mm unit the length of each size up to 100 ~ 400mm as originally desired.
On 2014-11-25 22:33:18
Thankfully it can be purchased at this much price.
After that we do not need the other manufacturers if Erabere more length and diameter.
To the axis of the pulley
On 2014-11-08 14:45:03
It survives very cheap.
After that I hope if it is possible to choose more length.
Extension of the shaft
On 2014-10-27 19:51:07
Cheap and convenient.
Precision enough, you want to use if someone is size.